:
• using cold water -
delicate cycle.
• .
• to prevent cover from shrinking.
wash EPE foam pad insert in backrest.
:
• using warm water and mild soap.
• .
• use solvents, abrasive cleaners, or
disassemble child restraint in any way, except as
instructed.
:
• Spot clean with a damp cloth. .
immerse the straps in water. Doing so may
weaken the straps.
1. The cup holder can be installed on
either side of the child restraint.
2. Locate the opening in the end of
either armrest.
3. Insert cup holder clip into the
opening and push in unl locked
into place. Ensure that the fabric
does not interfere with the installaon. If so, gently
pull down on the fabric while installing cup holder.
4. Pull out to remove.
: Reinstall harness system if applicable
(see “Removing/Installing harness”, pg. 37).
46
To Next Page
Loading...
