20 Chapter 2 | Installation and Setup
InfoCaster R2100 Hardware Installation Manual
Configure GPI
Triggers
Use the following procedure to enable your GPI device.
1 Select Start > Programs > Harris > InfoCaster R2100 > Configuration
Utility > InfoCaster R2100 Configuration Utility.
2 In the Configuration Utility, switch to the External Triggers tab.
Figure 2-7. GPI Device Configuration Dialog
3 Select the GPI Device used to trigger events.
• Live Link Installed (legacy device)
• Serial GPI
• U2IO Installed
• Software
4Click Ok
When systems are connected through a USB port, you can set an event on one
system to trigger an event on another system. See “Use Triggers to Play Other
InfoCasts” in Chapter 6 in the InfoCaster Software User Guide for more
information.
USB GPI triggers need to be added to the GPI list in the Configuration Utility
before they can be used in InfoCaster. See “External Triggers Tab” in Appendix
B in the InfoCaster Software User Guide for more information.
To Next Page
Loading...