39Chapter 2 | Installation and Setup
InfoCaster R2100 Hardware Installation Manual
Confirm the Video
Output
After configuring your video output and saving your settings, a warning dialog
appears stating that all Harris software will shut down and restart when exiting
the InfoCaster Configuration Utility.
Figure 2-27. Software Shutdown Warning
1 Click OK to continue with the setup. An ICConfig dialog appears asking if
you want to test your settings.
Figure 2-28. Settings Test Dialog
2 Click Yes to open the Test Pattern Output dialog.
3 Click the Start button and then OK when you see the color bars on your
output monitor.
Figure 2-29. Test Pattern Output Dialog
4 Click Yes on the Output Test dialog to confirm the color bars appeared
correctly, and to close the configuration utility.
If you did not see the color bars, return to “Select the Video Output
Device” on page 36 to reconfigure your video output.
To Next Page
Loading...