40 Chapter 2 | Installation and Setup
InfoCaster R2100 Hardware Installation Manual
Audio Configuration
Enable Live Audio
Input
If you have audio/video capture cards installed on your system, select the
Enable Live Audio/Video Input checkbox on the Video/Audio Standard tab in
the InfoCaster Configuration Utility. If you select this option, InfoCaster
enables you to use audio input from the cards within your Live Video regions.
Enable Audio
Output
In order for your InfoCaster system to output audio, select the Enable Audio
Output checkbox on the Video/Audio Standard tab. When selected, InfoCaster
uses the default audio device currently set up within Windows.
Configure the
Audio I/O
Use the Realtek control panel to change the Windows default audio device and
configure your audio settings.
1 To open the Realtek control panel, select Start > Settings > Control Panel
and then double-click the Realtek icon.
2 Select the Audio I/O tab.
Figure 2-30. Realtek Control Panel: Audio Tab
3 Connect an audio device into any of the audio I/O ports.
To Next Page
Loading...