25Chapter 2 | Installation and Setup
InfoCaster R2100 Hardware Installation Manual
Disable the Onboard VGA
If your computer motherboard has an onboard VGA there can be resource
conflicts with the ATI or NVIDIA cards. Your system administrator must disable
the onboard VGA in the computer BIOS, and in Windows XP.
Note: After running any other video enabled application, you must reboot the
computer before running InfoCaster.
Configure NVIDIA
Card Display
If the InfoCaster software is already installed on your system, do NOT open
InfoCaster until you have configured the output monitors. The system might
generate an error if InfoCaster is opened without properly configured output
monitors.
1 With the InfoCaster system shut down, connect the monitors to the
DVI/VGA ports on the back of the system.
2 Reboot the system and turn on the monitors. Make sure the monitors are
not in standby mode.
3 Select Start > Settings > Control Panel > Display to bring up the Display
Properties window.
4 Select the Settings tab.
5 Click on the number 1 monitor icon and select a monitor from the Display
drop-down list.
6 Select the “Use this device as the primary monitor” checkbox.
Figure 2-10. Primary Display Monitor
To Next Page
Loading...