32 Chapter 2 | Installation and Setup
InfoCaster R2100 Hardware Installation Manual
Configure ATI
Card Display
If the InfoCaster software is already installed on your system, do NOT open
InfoCaster until you have configured the output monitors. The system might
generate an error if InfoCaster is opened without properly configured output
monitors.
1 With the InfoCaster system shut down, connect the monitors to the
DVI/VGA ports on the back of the system.
2 Reboot the system and turn on the monitors. Make sure the monitors are
not in standby mode.
3 Right-click on the Windows desktop.
4 Select the Catalyst Control Center option to open the Control Center.
Figure 2-21. Catalyst Control Center
Note: When you first launch the Control Center you are prompted to
select the mode you wish to work in. Select Advanced mode.
5 Click on Displays Manager in the Graphics Settings pane.
To Next Page
Loading...