61Chapter 4 | Specifications
InfoCaster R2100 Hardware Installation Manual
Power Supply Specifications
Table 4-3 outlines the power supply specifications.
Communications interface RS-232C using TX,RX,RTS,DTR and GND.
One device per serial port.
Maximum communications
cable length
1000 ft (305 m) using recommended cable
type. Low capacitance shielded cable or UTP
is recommended.
Communications protocol Sensorsoft Device Protocol, Version 2.0
Error control 16 bit CRC (cyclic redundancy checking) for
detection of communication errors between
the device and host system.
Table 4-2. Temperature Probe Specifications (Continued)
Item Specification
Table 4-3. Power Supply Specifications
Item Specification
Operating Voltage 115 or 230 V AC (autoswitch) @ 60 HZ or 50 Hz
Input Range 90 to 132 V, 180 to 264 V AC selectable
Input Frequency 47 to 63 Hz
Input Current 10 A @ 115 V, 5A @ 230 V
Power Consumption 330 W maximum
To Next Page
Loading...