Harris Intelligent Transmitter Platinum-i Series - Organization of Transmitter Doc

______________________________________________HARRIS
888-9058-001
WARNING: Disconnect and lockout AC primary power prior to servicing
14
NOTE:
The HT60HS/LS Standard configuration system uses 2 Aural/Driver cabinets.
1.1.2 Organization of Transmitter Documentation
• The documentation consists of:
a. Platinum-i Analog Technical Manual (this manual)
b. Platinum-i Analog Drawing Package for High Band or for Low Band
c. HX1V Exciter Manual (a separate manual and drawing package).
• Organization of the Technical Manuals
The text part of the manual is divided into the following sections.
Section 1: Introduction
Section 2: Hardware Installation
Section 3: Software Installation and Setup
Section 4: Operation
Section 5: Control System Theory of Operation
Section 6: Control Cabinet
Section 7: PA Cabinet
Section 8: RF Modules
Section 9: 50 Volt Power Supply
Section 10: Parts Listing
There are different drawing packages for low band and high band systems: the drive
chains and modules are different. The drawing packages are organized in sections with
tab separators as follows:
10K SYSTEM or 15K SYSTEM COMMON SUBSYSTEMS
100 HT10H/11LSP i HT15H/LS i 600 Control System
200 HT20H/22LSP i HT30H/LS i 700 Control Cabinet
300 HT30H/33LSP i HT45H/LS i 800 PA Cabinet
400 HT40H/LSP i HT60H/LS i 900 50 Volt Power Supply
500 NOT USED 1000 High Power RF Modules