______________________________________________HARRIS
888-9058-001
WARNING: Disconnect and lockout AC primary power prior to servicing
64
Information in this section of the manual covers the basic setup and operation of the
remote networking side of the Display Unit (eCDi™).
3.3 Hardware
•
Single Board Computer. Includes a 20GB hard drive, 4 port internal ethernet switch
and power supply.
• 1 ethernet port mounted on the front of the unit for configuration and utility monitoring.
Eliminates the need to access the rear of the unit after installation.
• 1 ethernet port mounted on the rear for connection to the station LAN or WAN.
• 3 ethernet ports mounted on the rear for permanent interconnect to transmitters and
exciters that have an ethernet interface (RJ-45).
• 2 serial ports mounted on the rear for connection to transmitters and exciters with a
serial interface.
3.4 Features
Web GUI Interface - The Web GUI interface allows access to transmitter control,
status and logging for any of the supported transmitters via a standard web browser
interface (Netscape or IE). The only other software required is a Java plug-in and it is
downloaded from the eCDi™ the first time a computer accesses the unit.
Performance Monitoring - An optional software upgrade provides for performance
monitoring of DTV transmitters by networking an embedded version of the CD-EYE™
application.
Common Interface - The Web GUI creates a common display platform for all
transmitters. This allows immediate understanding of transmitter control and monitoring
regardless of the transmitter model.
Fault Logging - The fault log will hold up to 1000 events, is viewable on-line or can be
downloaded to Microsoft Excel or another common spreadsheet program.
Meter Logging - Meter logging occurs periodically at a customer configured time
interval. The Meter log will hold up to 1000 events and can be downloaded to Microsoft
Excel or another common spreadsheet program.
Email Notification - faults and warnings are automatically sent to a customer
configured email address.
SNMP Agent - provides for connection to the Harris Broadcast Manager (HBM)or
RECON remote control system. It can also be connected, in a limited form, to other
non-Harris based SNMP Network Managers. For more information about SNMP
connectivity see eCDi manual.
To Next Page
Loading...
