______________________________________________HARRIS
888-9058-001
WARNING: Disconnect and lockout AC primary power prior to servicing
83
Figure 3-15 Email Filters
• Selecting “None” (no filter) will allow all indications for the selected
category to send an email alert.
• Selecting “Sum” will block all Summary indications in the selected
category. All other indications in that category will send an email alert.
• Selecting “All but Sum” (the most common selection) will block all
emails but the Summary indications for the selected category (i.e. only
summary indications will send an alert email).
• Selecting “All” will block all emails for that category. This is most
commonly used for the Info category since these are mostly Status
indications.
NOTE:
Checking the “Local Mode” checkbox will disable all email alerts when the
transmitter is in Local mode (or Remote Disable as the case may be).
STEP 31: When all changes are made, press Submit and then press Back to return
to the main menu. Click on Applet to access the screen in Figure 3-16.
IMPORTANT:
When “Apply” is pressed on the Configuration main menu (shown in Figure 3-7),
the eCDi™ will send a test email to all of the addresses in the list. It will also send
SNMP Trap messages to all specified SNMP Network Managers.
To Next Page
Loading...
