HASLER Printing Section 3
Page 3 - 2 WJ20 06/2003
Printing Tips
If your mail contains staple fasteners, paper clips and other
fasteners, it is recommended that the fasteners be situated at
the bottom of the envelope. This will avoid the risk of damage
to your printing head. In the event that a satisfactory print
cannot be achieved due to bulky contents (Maximum .3
inches) the envelope should be treated as a packet and a
label (meter tape) used.
Envelope Specifications
Length 5.5” minimum No maximum
Depth 3.5” minimum No maximum
Thickness 3/8” maximum, use labels (meter tapes) for over
3/8 inches
Speed:20 envelopes per minute
Labels (Meter Tapes)
For an envelope exceeding 3/8 inch thick, a label must be
used.
For posting parcels or packets, a pre-cut self adhesive label
approved by Hasler should be used. When feeding a label,
select the postage value required and feed the label
into the machine in the same way as you would an
envelope. Take up the printed label, peel off the backing sheet
and affix the label to the parcel or packet.
To Next Page
Loading...