93
2.
Maintenance
2.1.
General
The type plate of the front linkage is placed on the front
part of the left frame bar.
1. Check regularly that all screws and nuts are tight.
2. Tighten all screws and nuts of the linkage after the first
15---25 running hours. Check also that the hydraulic
connections have no leaks.
2.2.
Maintenance every 50 hours
Grease the pins of the lifting cylinders and the shaft of the
lifting links with Valtra Universal Grease.
2.2. Detach Loader Safely
Detach the loader on a hard, level surface.
Before disconnecting hydraulic hoses, relieve all
hydraulic
pressure.
2.3. Avoıd Injury Or Death From Fallıng
Round Bales
To help prevent personal injury or death caused by
falling loads:
• DO NOT handle round bales unless loader is
equipped
with approved bale handling attachments.
Otherwise, the bale can fall on the operator when
the loader is raised.
• Lockout optional valve detents.
• Handle raised loads with caution.
• Carry loads low and drive slowly.
2.4. Transportıng Round Bales Safely
Follow the instructions in Operating the Round Bale
Fork or Operating the Grapple section of this
manual. Also, read the decals attached to both the
loader and the round bale fork.
To help prevent personal injury or accident caused
from a bale falling off the fork, carry the bale low
and slightly rolled back. Travel slowly over rough
ground.
DO NOT handle bales that exceed bale weight of
450 kg (1000 lb).
When handling round bales on a slope, always
approach the bale with the tractor facing uphill.
To help prevent personal injury because of lack of
visibility, do not handle bales that exceed a
diameter of 1372 mm (54 in.). Carry the bale low.
2.5. Dig Safely
Before digging, check location of cables, gas lines
and water mains.
Do not leave the operator’s seat if any part of
tractor or loader contacts cables.
2.6. Avoıd Power Lınes
Serious injury or death can result if tractor or loader
contacts electric lines.
Check height clearance before raising loader.
Do not leave the operator’s seat if any part of
tractor or loader contacts lines.
To Next Page
Loading...
