9.Troubleshooting
The syringe edge did not install into
the syringe fixed groove
Please install it correctly
The syringe currently used does
not match default brand
Select the correct brand of
syringe or self-defined syringe
Certain parts of the machine may
be defective
Contact distributor or
manufacturer for repair
Push handle can not
move freely
There is liquid on the screw
Wipe with a wet clean soft cloth
Besides the problems mentioned in 8.2, please contact the distributor or manufacturer for repair.
10. Safety Invention and Troubleshooting
10.1 Safety Invention and Precautions
(1). AC power: built-in double fuses. When short circuit or any other malfunction occurs, the fuse
shall cut off circuit in advance.
(2). DC input: built-in fuse. When short circuit or any other malfunction occurs, the fuse shall cut off
circuit in advance.
(3). Battery protection: The battery contains protective devices against excessive pressure, over heat
or short circuit, etc, to avoid overheating or burnt.
10.2 Troubleshooting
(1) If the syringe pump gives system error alarm, stop the operation and contact the sales agent for
repair. It can be used again only after it is well repaired and tested. Syringe pump works with malfunctions
may incur unpredictable damage.
(2) If the syringe pump catch on fire or displays any other malfunction, please disconnect the power
immediately and contact the sales agent/manufacturer.
11. Maintenance, Inspection, Repair and Recycling
Shutdown and disconnect the DC / AC power cord before cleaning.
To Next Page
Loading...
