HBM AED9101D - Table of Contents

AED9101D
2 I3563-1.0 en
1 Safety instructions 3........................................
2 Markings used 7............................................
2.1 Symbols on the device 7......................................
2.2 The marking used in this document 7...........................
3 Introduction 9..............................................
3.1 Scope of supply 9............................................
3.2 Application 9................................................
4 Design and function 11......................................
5 Mechanical installation 13....................................
6 Electrical connection 14......................................
6.1 Transducer connection 15......................................
6.1.1 Six-wire circuit (standard mode of operation) 15...................
6.1.2 Four-wire circuit 16............................................
6.2 Connecting the supply voltage 18...............................
6.3 Connection to a PC 19........................................
6.3.1 Connection via RS‐232 21.....................................
6.3.2 Connection via RS‐422 22.....................................
6.3.3 Connection via RS‐485 22.....................................
6.4 Using several AEDs (bus mode with RS‐485) 23..................
6.5 Connecting the diagnostic bus 25...............................
6.6 Trigger input 27...............................................
6.7 Cable connection via the PG gland 28...........................
6.8 Ground (GND) and shield wiring 29.............................
7 Selling on, waste disposal and environmental protection 31....
8 Index 33....................................................