©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
20
10 Preparing the Stud Welding Gun
10.1 Mounting the Chuck
ARC chuck
Tighten the retaining nut again with the 14/17 mm double
open-ended wrench.
You thereby simultaneously tighten the chuck adaptor.
Screw the chuck onto the adaptor.
Secure the adaptor with a 17 mm double open-ended
wrench.
Tighten the chuck with a 14 mm double open-ended
wrench.
Damage through twisting
Never tighten the chuck if the adap-
tor is not held with a second double
open-ended wrench!
The interior units or the basic shell could
otherwise twist and be damaged.
To Next Page
Loading...
