©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
12 Welding
12.3 Setting the Charging Voltage
First determine the necessary charging voltage.
Read and observe here Point 12.2 „Determining the Charging Voltage“.
Only now set the necessary charging voltage with the arrow buttons.
12.4 Performing the Welding Process
First set the necessary charging voltage.
Read and observe here Point 12.3 „Setting the Charging Voltage“.
Electric shock and light arc hazard
Never touch the welding elements, chuck, retaining nut or electrically con-
ductive parts in their vicinity during the welding process.
These parts are live.
Never wear metal jewellery, even a wristwatch, on your body during the
welding process.
This will help to avoid injuries and damage due to electric power or electro-
magnetic elds.
Electric shock and light arc hazard
Stand on an insulated mat if you have to weld under the following condi-
tions:
– In conned spaces with electrically conductive walls
– Under cramped conditions between or against electrically conductive
parts
– Where there is limited mobility on electrically conductive parts
– In damp, wet or hot rooms.
To Next Page
Loading...
