©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
12.2 Determining the Charging Voltage
Determination of charging voltage at the stud welding unit using the arrow keys
depends i.a. on
– the stud welding gun used,
– the material of the welding element,
– the diameter of the welding element,
– the material of the workpiece.
Determine the charging voltage to be set at the stud welding unit using the fol-
lowing tables.
The gures in these table are indicative values and must be checked
by means of a test welding on the original material with the same pro-
perties as the original workpiece.
To Next Page
Loading...
