Page
4
Heathkif
UNPACKING
UNPACK
ANY
PART OF
YOUR
KIT
UNTIL
A STEP
DIRECTS
Locate
the "Pack
Index Sheet" that is
packed inside
the main
shipping carton for
your Transceiver. Note
that
the shipping
carton is divided into
three smaller
sections. These
sections make up
Packs 1 and 2 and
the
Final Pack, and
may be made up of
several bags,
envelopes,
small boxes,
and loose parts. Do not
un-
pack any of these
parts until a step
specifically di-
rects you to do so.
When you
check parts
against
a
"Parts List,"
return
any part or group of
parts packaged in a bag
or other
container,
with
a
part
number on it, to its
container
after you identify
it. Leave these
parts there until
you actually use
them in a step.
This will help
pre-
vent you
from mixing up
the parts, and help you
identify the
parts when you
need them.
Some parts, however, are in
a bag
or envelope
that
is not marked with an actual part number,
but
with
a packaging number that
begins
with
the number
"173-."
These numbers
are used for packaging pur-
poses
only
and do not appear in the Manual "Parts
Lists." Open each bag or envelope
that is marked
with
only a
"173-"
packaging number to identify
the
parts
it
contains.
NOTE: Never
use a
"173-"
packaging number if
you
must order a replacement
part. Use only the part
numbers listed in the Manual Parts List for this
pur-
pose.
Save all of the packaging material until
you account
for all of the parts.
To Next Page
Loading...
Need help?
General
