Heathkit SB-220 - Page 22

Page 17
PICTORIAL 2-3
Refer to Pictorial 2.3 for the following steps.
Connect the prepared hookup wire from the coils to wafer
1
of switch CZ as follows:
(
Prepare the following lengths of black hookup wire.
Connect to
Wires are listed in the order in which they will be used.
Wire Connect From
Wafer 1 of
Length Lug 2 of
Switch CZ
2-112"
04 2-112" Coil CY 6-3) Lug 8 (S-3)
2"
14 2" Coil CX 6-21 Lug 9 6-3)
I dd 2-1 ns8 Coil cu 6-2) ~ug 10 6-31
i
(4 2-lnl1 Coil CT 6-2) LU~ 11 (s-3)
2-1 12"
t A 2.1~~~ Coil (23 6-3) Lug 12 6-3)