Heatmiser Touchpad (TFT) - Summer Mode; Activating and Deactivating Summer Mode; Quick View; System Zone Overview

3029
Touchpad Model: TFT
Temperature Hold (Multiple Zones)
The temperature hold function allows you to manually override the current operating
program of multiple zones and set a dierent temperature for a desired period
To set a temperature hold follow these steps.
• Press the Temp Hold icon ..............................................................................................
• Using the Up/Down arrow keys, set the hold temperature and duration ...
• Press the Next key ............................................................................................................
• Select which zones to apply the hold to .......................................................
• Press the Done key ...........................................................................................................
To cancel a hold in operation follow these steps.
• Press the Temp Hold icon ..............................................................................................
• Press the Cancel Hold key ...................................................................................
• Select which zones should have the temperature hold function canceled.
Zones in grey do not have a hold in operation.
Zones in green will have the hold canceled and those in blue will remain active.
• Press the Done key ...........................................................................................................
Summer Mode
Quick View
The Quick View screen gives an overview of all the zones on your system.
The zone temperatures as well as the output status are displayed.
You can use this screen to quickly access any zone on your system by rst
highlighting the zone and then pressing Detail.
The Touchpad Summer mode oers a quick and easy way to place selected heating zones
into set back without having to reprogram the comfort levels. The hot water times will
not be eected during summer operation.
The set back temperature can be set on each thermostat between 07-17°C or this can be
done from the Touchpad (See page xx)
As an indication, the heating zone screens will display the frost icon whilst the summer
mode is active. As a default, all heating zones will follow the summer condition, but you
can deselect certain zones if required. The setup should be as follows….
• Press Summer
• Zones buttons in green (selected by default) will follow the summer mode and
zones in blue will not.
• Press Zones to deselect any thermostat/s that you don’t want to apply summer to.
• Press Done.
To cancel summer mode....
• Press Summer.
• Select Functions tab.
• Press Unselect All.
• Select Done.