Touchpad Settings
Security Setup
The Touchpad has a security function that allows you to limit access, so for example
zone settings cannot be altered without entering a code.
To enable this function, follow these steps.
• Press the Options tab.
• Press the Settings icon .......................................................................................................
• Press the Security icon .......................................................................................................
• Move the toggle to ON and then set a security code.
• Press the Done key ..............................................................................................................
Note: If you forget or misplace your user code, contact your equipment supplier for
assistance.
• Press the Options tab.
• Press the Settings icon .......................................................................................................
• Press the System Info icon ................................................................................................
This screen displays the current version of your Touchpad
The master timer function can only be used with non-programmable thermostats.
During setup, you can select which zones should follow these times.
During the programmed time, the thermostat will control to its set temperature and
then outside of the programmed time it will control to its setback temperature
The brightness control enables you to control the brightness level of the Touchpad
display.
The calibration function can be used to recalibrate the touchscreen.
This is factory set and should not need to be adjusted.
The Touchpad can store 4 weeks of data per zone. To delete the history, use the delete
history function.
Touchpad Settings
Master Timer
Touchpad Settings
Display Screen
Touchpad Settings
System Information
Touchpad Settings
Delete History
To Next Page
Loading...
