Heatmiser Touchpad (TFT) - Hot Water Boost; Boosting Hot Water Output; Home; Away Mode; Activating Away Mode

3231
Touchpad Model: TFT
Hot Water Boost Home / Away Mode
If you have thermostats with hot water function on your system, you can override
the hot water output.
During an override, the thermostat will ash TIMER ON / HW ON depending on the
model of your thermostat.
To use this function, follow these steps;
• Press the HW Boost icon ...................................................................................................
• Using the Up/Down arrow keys enter the boost period ......................................
• Press the Done key .............................................................................................................
To cancel, repeat the steps reducing the boost time to 00 hours.
Once the boost period has ended, the zone will revert back to its programmed
setting.
Away mode places selected zones into setback mode indenitely for use when you
are unsure when the building will next be occupied.
The zones will control to the setback temperature during this time and the hot
water will be turned o.
Pressing Home will cancel the Away function, and the zones will revert back to their
programmed level.
As a default, all heating zones will follow the Away mode, but you can deselect
certain zones if required.
To place the system in away mode follow these steps.
• Press the Away icon ......................................................................................................
• Toggle the switch to the on position.
• Press the Edit key ..........................................................................................................
• Select zones to apply the Away mode to ..............................................
Zones buttons in green will follow the
Away mode and zones in blue will not
• Press the Done key ........................................................................................................