Heatmiser Touchpad (TFT) - Initial Setup; Adding Thermostats via Network Scan; Statistics Screen Overview

65
Touchpad Model: TFT
Up to 32 thermostats can be connected to the Touchpad and these are added by
performing a network scan.
Prior to performing the scan, a communication number needs to be entered in each of the
thermostats on the system.
You should consult the thermostat manual for instructions on how to do this.
Once you have entered a communication number in each thermostat, follow these steps;
• On power up of a new Touchpad, you should see the Network Scan screen.
• This screen shows 32 boxes which represents the 32 possible thermostats on your
system.
• To perform the network scan, press Scan.
If the box stays red, it means no thermostat has been found at that location.
If the box turns blue, it means a thermostat has been successfully identied.
If you have previously scanned the network and would like to perform a new network
scan, follow these steps;
• Press the Options tab.
• Press the Settings icon .......................................................................................................
• Press the Network icon ......................................................................................................
• Press Scan ...............................................................................................................................
Initial Setup
Adding thermostats to your system
Statistics
The statistics screen shows the communication rate to each of the thermostats on the
system.
This screen can help to identify problems on the network.