1
Installation Procedure
This Touchpad is designed to be ush mounted and requires a back box of 35mm
(minimum depth) to be sunk into the wall prior to installation.
Step 1
Carefully separate the front half of the Touchpad from the back plate by placing a
small at head terminal driver into the slots on the bottom face of the Touchpad.
Step 2
Place the Touchpad front somewhere safe.
Terminate the Touchpad as shown in the diagrams on page 43 of this booklet.
Step 3
Screw the Touchpad back plate securely into the back box.
Step 4
Clip the front of the touchpad back onto the wall mounting plate.
Do
Mount the touchpad at eye level.
Read the instructions fully so you get the best from our product.
Don’t
Do not push hard on the LCD screen as this may cause irreparable damage.
2
3 4
To Next Page
Loading...
