Heatmiser Touchpad (TFT) - Profiles Management; Editing a Profile; Deleting a Profile; Running a Profile

3837
Touchpad Model: TFT
Running a Prole
To run a prole , follow these steps.
• Press Proles icon and press the prole icon again ........................
• Select the Prole to run.
• Press the Run key .....................................................................................................
The settings will be sent immediately to the zones in the group and their zone
screen will show the prole is active.
Notes:
1. When you run a prole, all of the existing settings in the thermostat will be
overwritten with the prole settings.
2. Only one heating prole per zone can be run at once.
3. If the zone has a heating & hot water model thermostat, It is possible to run a
heating and a hot water prole at the same time. The Touchpad will indicate that
two proles are in operation.
Proles Continued
Editing a Prole
To edit a prole, follow these steps.
• Press Proles icon and press the prole icon again ..........................................
• Select the Prole to edit.
• Press the Edit key ........................................................................................................................
• Edit the prole.
• Press the Done key ....................................................................................................................
Deleting a Prole
To delete a prole, follow these steps.
• Press Proles icon and press the prole icon again ........................
• Select the Prole to delete.
• Press the Delete key ...............................................................................................