39 / 64
PL
SK
DE
EN
CS
HU
After starting let the engine run 1 – 3 minutes at low speed, in the meantime check
the engine condition, if it is running steadily or if you cannot hear unusual noise. Then adjust
the speed by throttle lever to required level.
(fig. 21) Engine control. The fuel supply is on the figure off, choke off, throttle lever on
Turtle symbol.
STOPPING THE ENGINE
MANUAL START ELECTRIC START (ONLY MODEL 8616 SE)
Having finished the work let the engine run for few minutes to let evaporate humidity and
melted snow and ice and the machine is dry for next use.
Throttle lever (fig. 20C / 21C) push to „Turtle“ symbol.
Switch (fig. 22A) turn to OFF position.
Fuel valve (fig. 20A / 21A) turn to OFF position.
In case of long operation break (after season) is recommended to mix additive to fuel as
a prevention of fuel deterioration and problems with restarting in the beginning of next
season. Do not use the fuel which is older that 14 days.
WARNING! B
Avoid by all possible means unintentional start the engine! This could lead to injury
of heavier character, in the worst case to the death.
DRIVE GEARS
CAUTION! A
Shift the gears only when the coupling is switched off (machine stands still and only
with the engine switched on).
Change gears by means of gear lever (fig. 26A).
Forward: F1 – slow, F4 – quick
Reverse: R1 – slow, R2 – quick
Before shifting gear check if the snow thrower is not blocked.
LIGHT (ONLY MODEL 8616 SE)
• Light on/off switch controls the rise and fall the spotlight (fig. 1E). Can be activated only
when the engine is running.
• Light on/off switch is switched on when switch is in „1“ position, in „O“ position the light
is switched off.
To Next Page
Loading...
