42 / 64
PL
SK
DE
EN
CS
HU
MAINTENANCE
Good maintenance is essential for safe, economical and trouble-free operation.
WARNING! B
Improper maintenance, or failure to correct a problem before operation, can cause
malfunction in which you can be seriously hurt or killed. Always follow the inspection
and maintenance recommendations and schedules in this owner’s manual.
WARNING! B
Disconnect the spark plug before performing any service on the machine. Wait till all
moving parts are completely stopped.
• To help you properly care for your engine, the following pages include a maintenance
schedule, routine inspection procedures, and simple maintenance procedures using basic
hand tools. Other service tasks that are more difficult, or require special tools, must be
performed by an authorized service centre.
• The maintenance schedule applies to normal operating conditions. If you operate your
engine under severe conditions, such as sustained high-load or high-temperature operation,
or use in unusual wet or dusty conditions, consult your servicing dealer for recommendations
applicable to your individual needs and use.
• After finishing season carefully clean the machine and all metal and moving parts lubricate
by grease or oil so that the machine would be prepared for next season. Before next
operation with the machine carefully check all the components.
• Frequently check fastening of all screws, nuts etc. in order to keep the machine in safe
working condition.
• Once in the season let inspect and maintain the machine in authorised service center.
CAUTION! A
Failure to properly follow maintenance instructions and precautions can cause you
to be seriously hurt or killed. Always follow the procedures and precautions in this
owner‘s manual.
HOW TO AVOID POSSIBLE DAMAGES ON THE MACHINE
If there are frequently caught by snow blower stones, branches or other object, stop the machine
and check possible damage. Found damage has to be repaired immediately, never continue
to work with damaged machine. Before starting work should the engine reach operation
temperature. Finishing the work let the engine run few minutes idle.
• Switch of the blower spiral when you change the place or if the snow blower is out of
operation do not overload the snow blower by driving too fast by snow cleaning.
• When you hit any solid object switch off the engine, disconnect the connector of spark plug,
check contingent damage before you start the engine again to continue working.
• In case of abnormal vibrations proceed according to instructions (see instruction for removal of fault).
To Next Page
Loading...
