50 / 64
PL
SK
DE
EN
CS
HU
DRAINING THE FUEL TANK AND CARBURETOR
WARNING! B
Gasoline is highly flammable and explosive, and you can be burned or seriously
injured when handling fuel.
• Stop engine, allow it to cool completely and keep heat, sparks, and flame away.
• Refuel only outdoors.
• Wipe up spills immediately.
1. Place an approved gasoline container below the carburetor, and use a funnel to avoid spilling
fuel.
2. Remove the drain bolt, then move the fuel valve lever to the ON position (if it is equipped).
3. After all the fuel has drained into the container, reinstall the drain bolt and washer. Tighten
the drain bolt securely.
ENGINE ADJUSTMENTS
C Do not change in any way the rated speed of the engine (carburetor side or regulator
side).
Your engine was adjusted in the factory and the non-respect of the homologation speed engine
could be dangerous for your safety and others safety. If the motor settings is changed in any
way, the warranty will be cancelled. If additional adjustment is necessary (eg. for high altitude),
contact authorized service center!
TRANSPORT
For manipulation with machine make following steps: Start the engine, grip the self-drive control
handle and drive the machine to required place. You can handle the machine also without self-
drive. Release the control lever and shift idle gear. Push the machine to required place.
TRANSPORT ON THE TRAILER
CAUTION! A
Let the engine to cool down before transporting the machine.
WARNING! B
The fuel tank must be empty. Spilled fuel or fuel vapor may ignite.
1. Empty the fuel tank before transporting the machine.
2. Empty the petrol tank with a suction pump. Start the engine and let it run until it has used
up all remaining petrol and stalls.
3. Close the fuel cap firmly.
4. Turn the engine switch and fuel valve (if equipped) to the off or stop position.
5. Let the engine to cool down before transporting.
To Next Page
Loading...
