40 / 64
PL
SK
DE
EN
CS
HU
INSTRUCTIONS FOR USING THE MACHINE
• Ensure good stability!
• Pressing the guide rod (fig. 1C) down will enable to turn the sweeping broom in both
directions by ca. 20° and lock the bar in those positions.
• In the operating mode, make always sure that the cooling and combustion air is exhausted
without interruption (leaves may block the exhaust channels). Flue gas exhaust without
interruption should be ensured, too.
• Before using the device on a wooded, grassy or brush-covered unimproved land install and
keep a spark arrester in working order.
OPERATION OF THE CLUTCH HANDLE
Operation of the walk-about cluth
• The walk-about clutch handle of the machine controls the working of the walk-about
driving wheels.
• When unpressed, the machine stays in idling state;
• When pressed down tightly, the machine is switched to moving state (changes in forward
moving speed can be realized by selecting different speed shifts).
OPERATION OF THE SCREWED CLUTCH HANDLE
• The screwed clutch handle of the machine controls of working of the sweeping brush.
• When unpressed, the machine is off the sweeping operation;
• When pressed back tightly, the machine starts the sweeping operation;
MACHINE CONTROL
• The appliance is moving forward when the upper lever (fig. 19A) is pressed and one of
the forward gears is ranked.
• The appliance is moving backward when the upper lever is pressed and one of the backward
gears is ranked.
• Brushes are activated when the lever (fig. 19B) in the middle of the handle is pressed.
• The cleaning appliance is fitted with a safety switch: brushes and appliance are disabled as
soon as levers are released.
• Pressing the guide rod (fig. 1C) down will enable to turn the sweeping broom in both
directions by app. 20° and lock the bar in those positions.
SUPPORTING WHEELS AND BRUSH HEIGHT ADJUSTMENT
As soon as the brushes are slightly worn out, distance of brushes from the ground must be
adjusted again. Set up the height of the support wheel by turning the adjusting cranks (fig. 27A).
Support wheel goes up - brushes are closer to the ground and conversely.
C The adjust of excessive pressure reduce brush life.
INSTRUCTIONS FOR USING THE SNOWBLOWER
(SNOWBLOWER = OPTIONAL ACCESSORY)
ADJUSTMENT OF CHUTE DIRECTION
Direction is controlled by turning the handle and height/distance of throwing is adjusted after
releasing the nuts of throwing tunnel.
To Next Page
Loading...
