53 / 64
PL
SK
DE
EN
CS
HU
• Store minimum quantity of the fuel which you can use to 14 days. Do not use fuel older
than 14 days.
DEVICE-SPECIFIC STORAGE INSTRUCTIONS
1. Store the machine in a dry, clean and frost-protected place, out of reach of unauthorized
persons.
2. Cover unit with a suitable protective cover that does not retain moisture. Do not use sheet
plastic as a dust cover. A nonporous cover will trap moisture around the machine, promoting
rust and corrosion.
3. Keep the machine in good condition, if necessary change warning and instruction labels on
the machine.
Note: I
When storing care should be taken to rust-proof the equipment. Using a light oil or
silicone, coat the equipment, especially all metal parts and all moving parts.
TROUBLESHOOTING
Problems which you meet while working with the machine have mostly very simple reason which
you can put easy in order by yourself. If your are in doubts or if the repair is more complicated,
or it is a failure which is not described here, contact authorised service center. All repairs let do
in authorised service centers, which used original spare parts.
Note: I
Failures of your machine which require larger interference must always be eliminated
by authorized service center. Unauthorized interferences can cause damages. If you can not
rectify the fault using the measures described here, contact an authorized service center.
ENGINE
Problem Probable cause Corrective action
Engine not starting
Engine switch not in “I“ position (ON)
Put the engine switch to “I“ position
Fuel tap closed Open the fuel tap
Non-correct position of choke lever
Cold engine - put choke lever into position
CHOKE
Hot engine - put the choke lever into
position RUN
Socket plug not fitted Fit the socket plug
Spark plug dirty or faulty Clean or replace the spark plug
Incorrect spark plug electrodes
distance
Set the correct gap between the electrodes -
see Specifications
Fuel tank empty Add fuel
Old fuel Replace old fuel with new one
Engine switching off after
being started
Air filter dirty Clean the air filter
Too big distance of spark plug
electrodes
Set the correct gap between the electrodes -
see Specifications
Spark plug dirty or faulty Clean or replace the spark plug
To Next Page
Loading...
