December 2001 List of Machine Parameters 4 – 59
MP7431 Arc end-point tolerance
Input: 0.0001 to 0.016 [mm]
PLC, CN123
RUN
6 – 326
MP7440 Output of M functions
Format: %xxxxxxx
Input: Bit 0 – Program stop with M06
0: Program stop with M06
1: No program stop with M06
Bit 1 – Modal cycle call M89
0: Normal code transfer of M89 at beginning of
block
1: Modal cycle call M89 at end of block
Bit 2 – Program stop with M functions:
0: Program stop until acknowledgement
of the M function
1: No program stop. Acknowledgement
is not waited for.
Bit 3 – Switching of k
V
factors with M105/M106
0: Function is not in effect
1: Function is in effect
Bit 4 – Reduced feed rate in the
tool axis with M103
0: Function is not in effect
1: Function is in effect
Bit 5 – Reserved
Bit 6 – Automatic activation of M134
0: M134 must be activated in the NC program
1: M134 is automatically activated when an NC
program is selected.
PLC, CN123
RUN
6 – 47,
6 – 123,
6 – 125,
6 – 286,
6 – 455
MP7441 Error message during cycle call
Format: %xxx
Input: Bit 0 –
0: Error message Spindle ? is not suppressed
1: Error message Spindle ? is suppressed
Bit 1: Reserved, enter 0
Bit 2 –
0: Error message Enter depth as negative is
suppressed
1: Error message Enter depth as negative is
suppressed
280 474-04
PLC, CN123
RUN
6 – 286
MP7442 Number of the M function for spindle orientation in the
cycles
Input: 1 to 999: Number of the M function
0: No oriented spindle stop
-1: Spindle orientation by the NC
280 476-09
PLC, CN123
RUN
6 – 201
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
