December 2001 Overview of Markers and Words 5 – 17
D 528-544 Target position for PLC positioning PLC PLC 6 – 35
D 528 Datum shift for axis 1 PLC PLC 6 – 399
D 532 Datum shift for axis 2 PLC PLC 6 – 399
D 536 Datum shift for axis 3 PLC PLC 6 – 399
D 540 Datum shift for axis 4 PLC PLC 6 – 399
D 544 Datum shift for axis 5 PLC PLC 6 – 399
W 560 - 568 Feed rate for PLC positioning PLC PLC 6 – 35,
6 – 235
W 576 - 584 Lag-tracking axis error compensation PLC PLC 6 – 44
D 592 Nominal position for spindle orientation PLC PLC 6 – 205
D 596 Max. feed rate from PLC [mm/min] NC/
PLC
PLC 6 – 128
D 604 Maximum possible spindle speed PLC NC/
PLC
280 474-03 6 – 184
W 754 % function for feed-rate override for free
rotation
PLC PLC 6 – 235
D 756 Programmed rotational speed or rotational
speed of the PLC [0.001 rpm]
NC/
PLC
NC/
PLC
6 – 189
D 760 Offset in tilting axes touch probe center
offset [1/10 000°]
PLC PLC 6 – 352
W 764 Percentage for spindle override (PLC to NC) NC/
PLC
NC/
PLC
6 – 191
W 766 Percentage for feed rate override
(PLC to NC)
NC/
PLC
NC/
PLC
6 – 237
D 768 - 956 Values from MP4210.0 to MP4210.47 NC NC 7 – 35
W 960 - 968 Value from MP4220.0 to MP4310.4 NC NC 7 – 36
W 976 - 988 Value from MP4310.3 to MP4310.6 NC NC 7 – 36
W 1008 S code for minimum speed NC NC 6 – 194
W 1018 Number of files opened by the PLC NC NC 280 476-03 6 – 301
W 1020 Number of open files NC NC 280 476-03 6 – 301
W 1022 Error status of the module last called NC NC –
W 1024 Axis release NC NC 6 – 130
W 1026 Axes in position NC NC 6 – 162
W 1028 Axes in motion NC NC 6 – 163
W 1030 Current direction of traverse NC NC 6 – 10
W 1032 Reference marks not yet traversed NC NC 6 – 102
W 1034 Positive software limit switch was traversed NC NC 6 – 25
W 1036 Negative software limit switch was
traversed
NC NC 6 – 25
W 1038 Preparing opening of the position control
loop
PLC PLC 6 – 131
W 1040 Axis-specific opening of the position control
loop
PLC PLC 6 – 131
W 1042 Deactivation of monitoring functions PLC PLC 6 – 156
Marker Description Set Reset SW Vers. Page
To Next Page
Loading...
