December 2001 Spindle 6 – 207
The following diagram shows the time sequence of the cycle:
MP3412.2 Multiplier for MP3411 during tapping
Input: 0 to 1.999
MP3415.2 Overshoot behavior of the spindle during tapping
Input: 0 to 1000 [ms]
MP7110.0 Minimum for feed rate override during tapping
Input: 0 to 150 [%]
MP7110.1 Maximum for feed rate override during tapping
Input: 0 to 150 [%]
MP7120.0 Dwell time for reversal of spindle rotational direction
Input: 0 to 65.535 [s]
MP7120.2 Spindle slow-down time after reaching the hole depth
Input: 0 to 65.535 [s]
F
0
S
0
M03
M05
M04
M4092
(M03) M4005
(M04) M4006
(M05) M4007
M4030
MP3411.x
MP7120.0
MP3412.2
MP3412.0
MP7120.2
Dwell time from
CYCL DEF 2.3
30 ms
Software controlled
Set Reset
M4030 Cycle 2 or Cycle 17 active NC NC
To Next Page
Loading...
