December 2001 Software Releases 2 – 49
NC software
280 472-08 (export
version 280 473-08)
Release: 07/98
Improvements:
n MP2510 and MP2511: Maximum input value reduced to 30 000
n MP2191: Decelerating spindle at EMERGENCY STOP
n MP6161: M function for orienting infrared probe before measurement
n MP6162: Orientation angle
n MP6163: Minimum difference before executing an oriented spindle stop
n New strings S4 to S7
n FN17 ID50: Overwrite data in tool table
n FN17 ID420: Effectiveness of cycles 7, 8, 10, 11, 26 and 19
n Module 9032: “No system memory” error code
n Module 9071, 9082, 9210: Transfer of an immediate string
n “Shut down” soft key to shut down the control
n Automatic tool compensation with the touch-probe cycles 421 to 426
n ISO: With G36 (spindle orientation) it is possible to program a Q parameter
as an angular value.
NC software
280 472-09 (export
version 280 473-09)
Release: 10/98
Improvements:
n MP6500 bit 13: Tilted system in which the tool is measured
n Module 9210: Path and name of the screen mask as an immediate string
n Cycle 420: Determine angle in the touch probe axis
n Cycle 427: Automatic length and radius compensation
NC software
280 472-10 (export
version 280 473-10)
Release: 11/98
Improvements:
n The version of the setup disks is also displayed via the MOD key.
NC software
280 472-11 (export
version 280 473-11)
Release: 11/98
Improvements:
n MP334: Number of grating periods between the zero pulses on encoders
with distance-coded reference marks
NC software
280 472-12 (export
version 280 473-12)
Release: 12/98
Improvements:
n Cycle 201, 202, 203: The default value in Q208 was increased to 30 000 mm
or 1200 inches
n Cycle 212, 214: The contour is approached at the programmed machining
feed rate
n Cycle 210, 211: The starting point for the finishing cut is approached at the
machining feed rate
n Cycle 421, 422: A basic rotation or a rotation via cycle 10 is considered for
the probing direction
To Next Page
Loading...
