HEIDENHAIN TNC 426 PB - Page 873

7 – 24 HEIDENHAIN Technical Manual TNC 426, TNC 430
Coordinate transformation
210 1 – Basic rotation (manual)
3 – Active mirrored axes
Bits 0 to 2 and 6 to 8:
Axes X, Y, Z and U, V, W
6 – Tilt working plane during Program
Run
(0 = inactive, –1 = active)
7 – Tilt working plane in Manual (0 =
inactive, –1 = active)
Exchange tool axis
212 ––0: Tool axis Z
1: Tool axis X
2: Tool axis Y
3: Tool axis from
TOOL CALL
Traverse range
230 2 1 to 9 Negative software limit switches in
axes 1 to 9
3 1 to 9 Positive software limit switches in
axes 1 to 9
4 Number of axes
whose software
limit switches
are to be
overwritten
Number of the first of several
consecutive Q parameters
1st Q: Neg. limit switch in 1st axis
2nd Q: Pos. limit switch in 1st axis
3rd Q: Neg. limit switch in 2nd axis
etc.
5 – Limit switch monitoring
(1 = off, 0 = on)
Tilting axes
290 1 – Tilting axis geometry description
TS touch-trigger probe
350 10 – Tool axis
11 – Effective radius
12 – Effective length
13 – Radius of calibration ring
14 1 Center offset (reference axis)
2 Center offset (minor axis)
15 – Center offset direction
Group
name
Group
number
ID....
System data
number
NR....
System data
index
IDX....
System data item