HEIDENHAIN TNC 430 PA - Page 298

4 – 60 HEIDENHAIN Technical Manual TNC 426, TNC 430
MP7450 Offsetting the tool change position from MP951.x in block
scan
Format: %xxxxxxxxx
Input: Bits 0 to 8 correspond to axes 1 to 9
0: Do not offset
1: Offset
PLC
RUN
6 – 295
MP7451.0-8 Feed rate for returning to the contour for axes 1 to 9
Input: 10 to 300 000 [mm/min]
PLC 6 – 295
MP7460 Angle for constant contour speed at corners
Input: 0.0001 to 179.9999 [°]
PLC, CN123
RUN
6 – 155
MP7470 Maximum contouring tool feed rate at 100% override
Input: 0 to 300 000 [mm/min]
0: No limitation
PLC, CN123
RUN
–
MP7471 Maximum velocity of the principle axes during
compensating movements through M128
Input: 0 to 300 000 [mm/min]
280 472-05
PLC, CN123
RUN
6 – 84
MP7475 Reference for datum table
Input: 0: Reference is workpiece datum
1: Reference is machine datum
(MP960.x)
PLC, CN123
RUN
6 – 302
MP Function and input Software
version and
behavior
Page