HEIDENHAIN TNC 430 PA - Page 299

December 2001 List of Machine Parameters 4 – 61
MP7480 Output of the tool or pocket number PLC
RUN
6 – 423
MP7480.0 With TOOL CALL block
Input: 0: No output
1: Output of the tool number only when
tool number changes
2: Output of the tool number with every
TOOL CALL block
3: Output of the tool and pocket
number only when tool number changes
4: Output of the tool and pocket
number output with every TOOL CALL block
5: Output of the tool and pocket
number only when tool number changes.
Pocket table is not changed.
6: Output of the tool and pocket
number output with every TOOL CALL block.
Pocket table is not changed.
MP7480.1 With TOOL DEF block
Input: 0: No output
1: Output of the tool number only when
tool number changes
2: Output of the tool number with every
TOOL DEF block
3: Output of the tool and pocket
number only when tool number changes
4: Output of the tool and pocket
number output with every TOOL DEF block
MP7490 Functions for traverse ranges
Format: %xxxx
Input: Bit 0 –
0: Display one traverse range via MOD
1: Display three traverse ranges via MOD
Bit 1 –
0: Each traverse range has its own datum
(and 3 memories for the positions of the swivel
head)
1: One datum for all traverse ranges
Bit 2 – Calibration data: touch probe for
workpiece measurement:
0: One set of calibrating data for all traverse
ranges
1: Every traverse range has its own set of
calibration data
Bit 3 – Calibration data: touch probe for
tool measurement:
0: One set of calibrating data for all traverse
ranges
1: Every traverse range has its own set of
calibration data
PLC
RUN
6 – 25,
6 – 350,
6 – 370
MP Function and input Software
version and
behavior
Page