5 – 6 HEIDENHAIN Technical Manual TNC 426, TNC 430
9160 Status request for temperature monitoring
and I
2
t monitoring
6 – 168
9161 Enabling the drive controller 6 – 145
9162 Status request of the drive controller 6 – 145
9163 Wye/delta connection switchover 6 – 214
9164 Reading the actual speed value of the
motor
6 – 135
9165 Sampling the current motor temperature 6 – 165
9166 Momentary utilization of the drive motor 6 – 169
9167 Supply voltage monitoring 6 – 164
9168 Interrogating the commissioning status 6 – 472
9169 Axes for which I32 does not switch off the
drives
280 474-10 6 – 145
9171 Oriented spindle stop 6 – 203
9175 Spindle switchover 280 474-03 6 – 216
9180 Simulation of NC keys 6 – 339
9181 Disabling individual NC keys 6 – 339
9182 Re-enabling individual NC keys 6 – 340
9183 Disabling groups of NC keys 6 – 340
9184 Re-enabling groups of NC keys 6 – 341
9186 Call a soft-key function 6 – 341
9187 Status of a soft-key function call 6 – 342
9189 Shutting down the control 280 476-03 6 – 249
9190 Starting the operating times 6 – 329
9191 Stopping the operating times 6 – 329
9192 Reading the operating times 6 – 330
9193 Setting the operating times 6 – 330
9194 Alarm when operating time exceeded 6 – 331
9195 System time 6 – 331
9196 Finding the PLC cycle time 280 476-05 7 – 3
9200 Display/delete PLC soft-key row 6 – 274
9201 Display/delete PLC soft key 6 – 275
9202 Select/deselect PLC soft keys and PLC
windows
6 – 275
9210 Opening or erasing screen mask for the
PLC window
6 – 266
9211 Status of the large PLC window 6 – 267
9215 Activating a PLC pop-up window 6 – 279
9220 Renewed traversing of the reference
marks
6 – 103
9221 Starting a PLC positioning movement 6 – 34
Module Function SW Vers. Page
To Next Page
Loading...
