December 2001 Overview of Modules 5 – 5
9100 Assign data interface 8 – 31
9101 Release data interface 8 – 32
9102 Status of data interface 8 – 32
9103 Transmit string through data interface 8 – 33
9104 Receive string through data interface 8 – 34
9105 Transmit binary data through data interface 8 – 35
9106 Receive binary data through data interface 8 – 36
9107 Read from receiving buffer 8 – 37
9110 Transmit a message via LSV2 8 – 38
9111 Receive a message via LSV2 8 – 39
9112 Transmit ASCII characters via data
interface
8 – 40
9113 Receive ASCII characters via data interface 8 – 41
9120 Starting a PLC axis 6 – 29
9121 Stopping a PLC axis 6 – 29
9122 Status of PLC axis 6 – 30
9123 Traversing the reference marks of PLC
axes
6 – 31
9124 Feed rate override for PLC axis 6 – 31
9125 Stop PLC axis at next Hirth grid position 6 – 32
9130 Output of an analog voltage 6 – 394
9133 Internal temperature of the LE 280 476-09 6 – 165
9135 Switch on 3-D touch probe 280 472-05 6 – 346
9145 Actual-to-nominal value transfer 280 472-07 6 – 132
9146 Saving and reestablishing actual position
values
280 476-13 6 – 219
9147 Assigning the reference value to an axis 280 474-04 6 – 100
9151 Selecting traverse range and axis
designation
6 – 23
9152 Selecting traverse range, axis display and
axis designation
280 476-01 6 – 24
9153 Switching the touch probe axis 280 474-07 6 – 350
9155 Axis switchover from closed loop to open
loop
280 474-04 6 – 219
9156 Axis switchover from open loop to closed
loop
280 474-04 6 – 220
9157 Drive controller status 280 476-13 6 – 144
9158 Maximum torque 280 476-01 6 – 171
9159 Drives that are switched off in 200 ms 280 474-10 6 – 144
Module Function SW Vers. Page
To Next Page
Loading...
