2 – 64 HEIDENHAIN Technical Manual TNC 426, TNC 430
n FN17 ID290: Activate tilting-axis geometry description
n FN18 ID290: Ascertain tilting-axis geometry description
n FN17 ID210: Tilted working plane in Manual mode
n FN18 ID210: Is tilted working plane in Manual mode active?
n FN17 ID230: Turn limit switch monitoring on and off
n FN17 ID501: Write to REF-referenced datum table
n FN18 ID501: Read from REF-referenced datum table
n FN17 ID20: Switchover spindle 1 / spindle 2
n FN31: Switch range of traverse, axis assignment, axis display
n FN32: Setting the datum
n Module 9044: Reading the spindle coordinates in 0.0001°
n Module 9097: Selecting the geometry description
n Module 9161, 9162: The bit for the spindle or the axis can be transferred
with C-axis operation
n Module 9189: Shut down the control
n Module 9291: Calling an NC macro
n Strings can be shown in the TABLE function
n Before the PLC program is converted, the PLC outputs are reset.
n Various LSV2 telegrams are entered in the log book.
n Two M functions in one NC block
n New NC blocks: SEL TABLE, SEL PATTERN and CYCL CALL PAT
n Cycle 208: Parameter Q342
n Cycle 247: Coordinates always interpreted in reference coordinates
n Cycles 262, 263, 264, 265, 267: Thread milling
n Cycle 209: Tapping with chip breaking
n Cycles 410 to 418: Also function when a basic rotation is active.
n Sample tables are copied into the appropriate directories with COPY
SAMPLE FILES.
n Multiple empty coordinate fields in NC programs are skipped.
n If a company logo is displayed, the control description is no longer shown.
NC software
280 476-04 (export
version 280 476-04)
Release: 09/99
To Next Page
Loading...
