December 2001 Software Releases 2 – 65
NC software
280 476-05 (export
version 280 477-05)
Release: 10/99
Improvements:
n MP2602, MP2604: Integral Phase Compensation - IPC
n Temperature compensation with M128 etc. through the description tables
of the tilting-axis geometry
n The selected geometry description is indicated in the program
management.
n Input range of the STR column in the motor tables expanded
n A DSP error message appears if the ready signal is missing from the speed
encoder inputs for vertical axes.
n Direction monitoring of digitally controlled spindles
n M4179: Control is shut down
n M4230: NC start via LSV2
n M4231: NC stop via LSV2
n M4220: Error from PET table/F stop active
n M4221: Error from PET table/NC stop active
n M4222: Error from PET table/EM. STOP active
n Module 9002, 9003, 9005, 9008, 9009: Error code 24 (Module was called in
the submit job or spawn job) added
n Module 9007: Diagnostic information of the PL
n Module 9040, 9041: Coordinate type 8 (temperature compensation from
description tables) added
n Module 9087: Status of PLC error message
n Module 9098: Ascertain the active geometry description
n Module 9130: New error codes 1 (Invalid analog output) and 2 (Disabled
analog output) added
n Module 9158: The torque of the active spindle can also be limited
n Module 9189: The drive ready signal is removed
n Module 9196: Finding the PLC cycle time
n Improved search function
n ISO: A Q parameter can be entered for the feed rate after M128 or G80
n ISO: The Q key of the numerical keypad or the ASCII keyboard may be used
n When the control is shut down, the hard disk is put into sleep mode.
n Cycle 440: Heat compensation
To Next Page
Loading...
