Helmholz NETLink PRO Series - WinCC V7.4 (Siemens AG); Add the protocol driver

NETLink
®
PRO family Application Examples
45
10 WinCC V7.4 (Siemens AG)
The following steps must be performed in the described se-
quence (Version November 2017):
10.1
Add the protocol driver
To parameterize a RFC1006 link in a WinCC project, a new
TCP/IP link must first be created in the ‘SIMATIC S7 PROTO-
COL SUITE.’
• Right click: Tag Management -> Add new driver…
• Select: ,SIMATIC S7 Protocol Suite.chn’
• create a new TCP / IP connection in ‚SIMATIC S7 PRO-
TOCOL SUITE’
• ‘Open’ the Tag management.