NETLink
®
PRO family Application Examples
11 WinCC flexible 2005/2007 (Siemens AG)
The following steps must be performed in the described se-
quence (status April 2008):
11.1
Configuring connections
Start WINCC flexible Project and open the connections in the
communications register:
• Select communications driver "SIMATIC S7 300/400"
• Interface: Ethernet
• The operator panel address is the local IP address of the com-
puter network card
• Access point: S7ONLINE
• The Control address is the IP address set in NETLink
®
• The Slot is the MPI address of the CPU to be addressed
To Next Page
Loading...
Need help?
General
