Users Manual Henkovac 04-serie V2019
Service Symbol
o After a number of operating hours or packing cycles, the
service symbol will briefly appear on the display
when the machine is turned on. In addition, the display
indicates how many hours or cycles remain before an oil change is required
o Except for regularly changing the oil in the pump (important!), the machine requires lit-
tle other routine maintenance
o To reset the service interval counters after the oil change: Start machine and while
the display shows the hours or cycles, press and hold the button
6.3 Ten-Program Control System
In addition to vacuum and sealing times, Henkovac machines with a Ten-Program control system may
be programmed for several additional functions. Each of the 9 customizable programs is either
1. time-controlled
2. sensor-controlled
6.3.1 Time-Based Operation (vacuum gauge: mbar)
The values for vacuum and sealing time, as well as the values
for several optional functions, are selected by the customer
and saved in any of 9 customizable programs P1-9
When operating a packaging machine with a time-based
program, the actual vacuum pressure is indicated by the
analog vacuum gauge. The number of seconds of vacuum time
remaining is shown on the LCD display
Plug & Play
When turning on a time-based machine for the first time, it will start up in the PA program
. This is a pre-set factory program with 30-40 seconds vacuum time and 2 seconds of
sealing time
When turning on the machine after that, it will start up in the most-recently used program
6.3.1.1 Optional installation of a Sensor or Soft-Air
A machine with a time-based control program can be upgraded to sensor-based operation at a lat-
er date by installing the optional sensor kit
The Soft-Air feature can also be installed at a later date by ordering the optional soft-air kit
6.3.2 Sensor-Based Operation (digital display: mbar)
When operating a packaging machine with a sensor-based
program, the actual vacuum pressure is digitally shown on
the LCD display in mbar (standard setting) or in % vacuum
Plug & Play
When turning on a sensor-based machine for the first time, it will start up in the PA program
. This is a pre-set factory program with 5 mbar of vacuum and 2 seconds of
sealing time
When turning on the machine after that, it will start up in the most-recently used program
To Next Page
Loading...
