Henkovac D3 - Recommended Spare Parts; Spare Parts Catalog

Users Manual Henkovac 04-serie V2019
Page 29 of 32
There is not enough gas in
the bag
The bag is too small
Select a bigger bag
The programmed gas level is too low
Increase the gas level value
The bag is not correctly positioned over the
gas outlets
Adjust the bag position
The machine does not seal
The bag is not correctly positioned over the
sealing beam
Adjust the bag position
The sealing wire is broken
Replace the sealing wire
The thermal safety of the power supply was
tripped
Wait until the safety resets, which can take
half an hour. Decrease the sealing time
The electrical contacts of the seal beam
have fouled
Remove the seal beam and clean the pins
and contacts with sand paper
The service symbol
appears when turn-
ing on the machine, indi-
cating the remaining pro-
duction hours or cycles
The service interval counters have reached
their maximum programmed values
To reset the service interval counters
after the oil change: Start machine
and while the display shows the hours
or cycles, press and hold the but-
ton
13.0 Recommended Spare Parts
Part No.
Description
Seals
9705.00040
Silicon T-profile (Length 5mtr)
9705.00045
Sealing Wire 3,5 x 0,3 (Convex, length 5mtr)
9705.00050
Sealing Wire Ø1,1 (Clean Cut, length 5mtr)
9705.00055
Teflon Tape (Length 5mtr)
11.09.0.0040
Sealing Wire 5 x 0,2 (Flat)
11.09.0.0040
Sealing Wire 8 x 0,2 (Flat)
Pump Parts
03.01.1.0020
Oil exhaust filter for 021m
3
/
h
03.01.0.0160
Oil exhaust filter for 016m
3
/
h
03.01.1.0080
Oil exhaust filter for 040m
3
/
h
03.01.1.0030
Oil exhaust filter for 063 and 100m
3
/
h
03.01.1.0040
Oil exhaust filter for 160 and 300m
3
/
h
03.01.1.0170
Oil filter for 040, 063 and 100m
3
/
h
03.01.1.0060
Oil filter for 160 and 300m
3
/
h
03.01.1.0220
Oil ISO VG32 (1 Ltr)
03.01.1.0120
Oil ISO VG100 (1 Ltr)
0301.00000
Oil ISO VG100 (1 Ltr) PRIVATE
Miscellaneous
9705.00035
Seal 8mm for transparent lid (Length 5mtr)
0504.00045
Silicone profile for stainless steel cover