HERMOS LFM LP Reader - N - Reset

Protocol description ASCII, SECS/HSMS
Customer manual
Version 1.2
LFM LP Reader 15.01.2019
Page 49 of 119
HERMOS AG
Gartenstrasse 19 Tel. +49(9279) 991-0
D-95490 Mistelgau Fax. +49(9279) 991-100
10.4.7 N – Reset
The command N performs a reset of the hardware/software of the reader.
After performing the reset operation, the device sends a confirmation message.
Host  Device
CMD
Reader-ID
N
1 Byte
Device  Host
CMD
Reader-ID
n
1 Byte
After a hardware reset, a confirmation ("n0") is sent to the host.
If TCP / IP is used as the interface, it will not be received because an existing TCP / IP connection is
interrupted by the reset.