Ex manual Rev 0 - Oct 29, 2014 17
2.4.2. Safety checks and starting the radio remote control
Check the charge state of your transmitter’s rechargeable battery
In the event that your transmitter is equipped with a STOP button, ensure that it is not
activated. If the button is activated, unlock it.
Start the machine to be controlled remotely.
If your transmitter has a green START button, press it or start the transmitter by turning the
key switch. The radio signal and the STOP relay remain active until the transmitter is
switched off.
Press one of the function buttons of the transmitter and keep it depressed.
Check the EMERGENCY STOP function as described in the manufacturer's manual,
however, instead of pressing the EMERGENCY STOP button on the machine, press the
STOP button on the control panel of the transmitter.
Press the STOP button on the transmitter. Once you have pressed the stop button on the
transmitter, it should no longer be possible to exercise control over any of the machine’s
functions!
Have you completed the checks and does the STOP system function properly?
Next release the function button and unlock the STOP button on the transmitter again.
After the STOP button has been unlocked and the transmitter restarted, the system is ready
for operation again.
Push-Pull STOP button Push-Turn STOP button
(Fig. 4) (Fig. 5)
To Next Page
Loading...
