Ex manual Rev 0 - Oct 29, 2014 19
cabinet or a vehicle, or is installed
inside the machine to be controlled.
The aerial is inadequate.
A radio remote control system with
the same frequency is being used
within the vicinity.
Individual functions cannot be
actuated or controlled.
Break in the control lead between
the machine and the receiver.
Check that the connector plug is properly seated.
Check the connecting cable to the machine. Check
the wiring and carry out cable-based control
checks of the individual functions if necessary.
Output module in receiver is
defective.
Check that a LED illuminates on the output
modules in the receiver in response to actuating
the corresponding function.
(EX-receivers must only be opened by
authorised and trained personnel.)
Contact your dealer for details.
2.6. Frequencies and addressing
Radio remote control systems from HETRONIC include a CS419, CS429, CS434, CS447 or CS458
RF module synthesizer.
The transmitter must never be used without an aerial, as this can
destroy the RF module.
The address is preset by HETRONIC. If you should experience
difficulties with the radio link in your system, please contact your
dealer or closest HETRONIC’s Service Centre.
To Next Page
Loading...
