HETRONIC EX Series - Qualified Operator Responsibilities; Working Area Safety Measures

Ex manual Rev 0 - Oct 29, 2014 7
When taking the spare battery into the hazardous area, it is absolutely necessary
for the operator to keep it with him.
The antenna and battery of the Ex-Transmitter must ONLY be changed OUTSIDE
the hazardous area.
1.4. Qualified Operators
(Refer to the operating instructions for the machine you intend to operate with remote control).
The operator is responsible for ensuring that when the transmitter is put aside, it cannot be used by
unauthorized persons. This can be done either by pulling the key from the key switch, by removing
the rechargeable battery or by storing the transmitter in a locked location.
The owner of the controlled equipment must:
 Provide the operator with these operating instructions
 Ensure that the operator has read and understood them.
The operator of the system is committed to:
Keep radio in a good and safe working condition.
Operate the systems properly.
Regularly check the radio remote control unit to ensure that the explosion
protection is still guaranteed.
1.5. Safety Measures to be taken within the working area
The user should ensure that the working area in which the radio control will be used is free from any
risks for the movement or other potential hazards that could jeopardize the safe operation of the
controller equipment. Before every use of the radio remote control unit, the user must check that
nobody is within the working area of remote controlled equipment. If a carrying aid is prescribed for
your transmitter, this must be worn during use.
Ex manual Rev 0 - Oct 29, 2014 7
When taking the spare battery into the hazardous area, it is absolutely necessary
for the operator to keep it with him.
The antenna and battery of the Ex-Transmitter must ONLY be changed OUTSIDE
the hazardous area.
1.4. Qualified Operators
(Refer to the operating instructions for the machine you intend to operate with remote control).
The operator is responsible for ensuring that when the transmitter is put aside, it cannot be used by
unauthorized persons. This can be done either by pulling the key from the key switch, by removing
the rechargeable battery or by storing the transmitter in a locked location.
The owner of the controlled equipment must:
 Provide the operator with these operating instructions
 Ensure that the operator has read and understood them.
The operator of the system is committed to:
Keep radio in a good and safe working condition.
Operate the systems properly.
Regularly check the radio remote control unit to ensure that the explosion
protection is still guaranteed.
1.5. Safety Measures to be taken within the working area
The user should ensure that the working area in which the radio control will be used is free from any
risks for the movement or other potential hazards that could jeopardize the safe operation of the
controller equipment. Before every use of the radio remote control unit, the user must check that
nobody is within the working area of remote controlled equipment. If a carrying aid is prescribed for
your transmitter, this must be worn during use.
Ex manual Rev 0 - Oct 29, 2014 7
When taking the spare battery into the hazardous area, it is absolutely necessary
for the operator to keep it with him.
The antenna and battery of the Ex-Transmitter must ONLY be changed OUTSIDE
the hazardous area.
1.4. Qualified Operators
(Refer to the operating instructions for the machine you intend to operate with remote control).
The operator is responsible for ensuring that when the transmitter is put aside, it cannot be used by
unauthorized persons. This can be done either by pulling the key from the key switch, by removing
the rechargeable battery or by storing the transmitter in a locked location.
The owner of the controlled equipment must:
 Provide the operator with these operating instructions
 Ensure that the operator has read and understood them.
The operator of the system is committed to:
Keep radio in a good and safe working condition.
Operate the systems properly.
Regularly check the radio remote control unit to ensure that the explosion
protection is still guaranteed.
1.5. Safety Measures to be taken within the working area
The user should ensure that the working area in which the radio control will be used is free from any
risks for the movement or other potential hazards that could jeopardize the safe operation of the
controller equipment. Before every use of the radio remote control unit, the user must check that
nobody is within the working area of remote controlled equipment. If a carrying aid is prescribed for
your transmitter, this must be worn during use.