CP : control panel, FC : frequency converter, SB : supply board, CB : cooling board, CC : control cable, LL : lid locking, BC : braking chopper,
BR : brake resistor, MR : mains reset, EC : error cause, ES : error consequence, ER : error remedy, M : measurements, ECR : error-code reset
16/51
IMBALANCE
EC Imbalance on motor axle.
ES The centrifuge slows down until the “open the lid” release occurs.
Further cooling until NOMINAL temperature is reached.
ER
• Weight difference in rotor components.
• Supporting lugs not lubricated.
• False IMBALANCE MODE is set (see chapter "Imbalance Mode").
• Imbalance switch not connected.
• Imbalance switch is defective.
• Loose contact in cable or plug.
• CC to CP is defective.
• CP or SB is defective.
M Also see at SB-X3 and CP-X1 (PIN 12)
ECR Perform an MR.
CONTROL - ERROR 04
EC LL is open during centrifugation.
ES Slowing down until the ”open the lid” release occurs.
Further cooling until NOMINAL temperature is reached.
ER
• LL is defective and can be opened during centrifugation.
• Loose contact in cable or in plug.
• CC to CP is defective.
• CP or SB is defective.
M Also see at SB-X5 (PIN 2 and PIN 6) and CP-X1 (PIN 5).
ECR Perform an MR.
N > MAX 05
EC Excess speed. The speed recognized by the speed sensor
(speedometer) is 250 RPM greater than the n-max speed of the rotor.
ES The centrifuge slows down until the ”open the lid” release occurs.
Further cooling until NOMINAL temperature is reached.
ER
• Insulation of speed sensor (speedometer) cable is defective.
• Loose contact on speed sensor (speedometer) cable.
• Speed sensor (speedometer) is defective.
• CC to CP is defective.
• CP or FC or SB is defective.
ECR Perform an MR.
To Next Page
Loading...
Need help?
General
